A SERVICE OF

logo

27
4 Connect one end of the Control Cable to the control port, as shown below.
5 Connect the individual connectors of the
Speaker Cable to the corresponding connectors inside the
screen. Match up the
L (Left), C (Center), and R (Right) labels on the connectors. Leave the 4-pin
connector unconnected for now (it will go to the projector).
6 Place one end of the
Video Cable near the middle of the screen. You will connect it later.
7 Locate
AC CABLE 3 (Y-shaped cable), which is packed in the AC power cable box inside box #5 with the
subwoofer.
Note
Let the loose ends of the cables connected in the following steps hang out from the middle of the screen. You will
connect them later.
To AV controller
(do not connect yet)
Cables inside
screen
To subwoofer
(do not connect yet)
Do not connect yet
To AV controller
(do not connect yet)
Place connector near
middle of screen