Installing the
CD player
11
To connect to other Meridian G Series, 500 Series, or 800 Series equipment
COMMS
COMMS LEAD COMMS LEAD
G Series, 500 Series, or 800 Series unit
COMMS
G07/G08
In a system of Meridian products, one of the products acts as
the controller for the system, receiving infra-red commands from
the MSR+, and then, if appropriate, relaying them to the other
products via the Comms link.
The following procedure should be used to set up the Comms
correctly between several products:
•Connect one of the DIN COMMS sockets on the back panel of
the CD player to one of the COMMS sockets on another G Series,
500 Series, or 800 Series unit, using the Comms leads provided
with the products.
The sequence in which you connect the units is not important.
•Switch all the units to standby.
•Press Clear (MSR+).
Each unit will display:
Auto
One unit will then be designated as the controller, and display:
Con.
All the other units will be configured as non-controllers, and
display:
Not Con.
If for any reason the automatic setup does not work, make sure
you are operating the MSR+ from a position where all the units
can receive the infra-red, and try again.
If this fails:
•Restore the default operation by selecting one of the standard
types; see
Resetting the product
, page 13.
Note: Do not, under any circumstances, connect any equipment
other than Meridian G Series, 500 Series, or 800 Series to any
socket marked COMMS on the back of the product.
G Series CD Player 11 12/9/03, 2:26:44 pm
