II. Installing the SeriTek/2SE2-E
Caution:
Prior to installing the SeriTek/2SE2-E host adapter and hard drive(s) or peripheral(s),
please make sure your data is backed up.
The SeriTek/2SE2-E host adapter and your PC contain sensitive components that can be
permanently damaged by Static Electric Discharge. Be sure you’re working in an area free of
static electricity to prevent them from being damaged. Use a wrist grounding strap if you
have one or regularly touch a metal part of the computer chassis such as the power supply
case or a port access cover to discharge any built-up static electricity from your body. Make
sure to handle the SeriTek/2SE2-E host adapter by its bracket or around its edges to avoid
damage to the card by static electricity.
Introduction
This section describes the proper method of installing your SeriTek/2SE2-E.
SeriTek/2SE2-E PCI Express Host Adapter Installation:
1. Properly shut down your PC and disconnect the AC power cord.
2. Depending on the model of your PC, open the side panel or top cover. Please refer to
your PC user’s manual for more information about gaining access to the PCI Express
slots.
3. Choose an empty PCI Express expansion slot where you will install the SeriTek/2SE2-E
(The SeriTek/2SE2-E can be installed in any available PCI Express slot – 1X, 4X, 8X,
etc.)
4. Remove the screw and detach the PCI Express expansion port access cover secured to
the computer case.
5. Remove the SeriTek/2SE2-E from its protective materials. Make sure to hold the card
around by its bracket or around its edges to avoid touching components which might be
damaged by static electricity.
6. Position the PCI Express card bracket by facing it towards the rear of the computer.
Align the gold connectors of the SeriTek/2SE2-E over the PCI Express slot and gently
press it into the PCI Express slot until the card is firmly seated. If the card is properly
seated, the upper ear of the PCI Express card bracket should line up with the screw
mounting location.
7. Using the same screw that was removed earlier; secure the card to the computer case
(See Figure 1).
Caution: The SeriTek/2SE2-E host adapter support external cables that may be
plugged in to one of its two external receptacles. If the SeriTek/2SE2-E is not properly
secured when a cable is inserted into one of the receptacles, it may become loose from the
PCI Express slot and damage the computer.
