3-7
26. Choose the height of the antenna above the water surface and then press the ENTER
soft key.
27. Choose STC CURVE and then press the EDIT soft key.
STC CURVE
▲
{
NARROW
~
NORMAL
{
WIDE
▼
28. Choose appropriate STC curve setting and then press the RETURN soft key.
NARROW: The effective range of the A/C SEA adjustment is relatively short.
NORMAL: Between NARROW and WIDE.
WIDE: The effective range of the A/C SEA adjustment is relatively long.
29. If you are going to use the equipment as a remote display, choose MONITOR
MODE and then press the EDIT soft key. If not, go to step 31.
MONITOR MODE
▲
{
ON
~
OFF
▼
30. Choose ON and then press the ENTER soft key.
•
TX blanking function is not available when the MONITOR MODE is ON. To set a TX
blanking sector, select OFF from MONITOR MODE on the NavNet equipment, and
then set the sector same as the main radar. Finally, set MONITOR MODE to ON.
•
When the MONITOR MODE is ON, the following functions are not available.
•
Tuning (auto/manual, on the RADAR SETUP menu)
•
Antenna rotation (RADAR SETUP menu)
•
TX sector blanking (RADAR DISPLAY SETUP menu)
•
Watchman (RADAR DISPLAY SETUP menu)
•
Pulse select (Soft key)
31. Choose HEADING ADJUST and then press the EDIT soft key.
HEADING ADJUST
▲
{ ON
~ OFF
▼
32. Choose ON and then press the ENTER soft key.
You have mounted the antenna unit facing straight ahead in the direction of the bow.
Therefore, a small but conspicuous target dead ahead visually should appear on the
heading line (zero degrees).
In practice, you will probably observe some small error on the display because of the
difficulty in achieving accurate initial positioning of the antenna unit. The following
adjustment will compensate for this error.
