3-12
WAAS setup (requires GPS receiver GP-320B/330B)
Press the WAAS SETUP soft key to show the WAAS SETUP display.
Contents of WAAS SETUP menu
Item Description Settings Default Setting
WAAS Mode Select ON to use the WAAS mode. On, Off Off
WAAS
Search
WAAS satellite can be searched
automatically or manually. For manual
search, enter appropriate WAAS satellite
number.
Auto, Manual Auto
WAAS Alarm When the WAAS signal is lost, the
audible alarm sounds with the visual
message “NO WAAS SIGNAL.”
On: Alarm continues to sound until the
WAAS positioning mode is available
again or the alarm is recognized by key
operation.
Off: Alarm sounds three times.
On, Off Off
Corrections
Data
Selects the type of message for WAAS
correction. Use “00” (operational status)
in North America; “02” in other locations.
00 to 27, 99 02
39. After you have finished setting up the GPS receiver, it’s now time to set up external
equipment. Press the NEXT soft key to show the DATA1 (GPS/NMEA) port setup menu.
It is only necessary to set up ports which you are going to use; skip unnecessary steps.
If you do not have external equipment connected to the NavNet, press the NEXT
key several times to show the “FINISH AND EXIT INSTALLATION WIZARD” screen
and then push the ENTER knob to finish.
OUTPUT FORMAT NMEA0183
Ver 2.0
LAT/LON FORMAT DD'MM.MMM'
XTE FORMAT X. XX
OUTPUT DESTINATION NO
Installation wizard, DATA1 (GPS/NMEA) port setup menu
40. Choose item and press the EDIT soft key. Choose appropriate setting and then press
the ENTER soft key. Refer to the table and sentence description on the next page for
details.
41. Press the NEXT key, and the DATA2 (NMEA) port setup menu appears. Set up this port
similar to how you set up the DATA1 port.
OUTPUT FORMAT NMEA0183
Ver 2.0
BAUD RATE 4800bps
LAT/LON FORMAT DD'MM.MMM'
XTE FORMAT X. XX
OUTPUT DESTINATION NO
Installation wizard, DATA2 (NMEA) port setup menu
