A SERVICE OF

logo

2. WIRING
2-2
Connection of WAGO connector
Remove the WAGO connector from each unit and connect each cable core to the
WAGO connector. See the interconnection diagram at the back of this manual. The
terminal opener is attached inside each unit.
2.1 Distributor Unit DS-610
The Distributor Unit DS-610 has two lines of cable clamps, and there are 13 cable en-
trances in total. The cables and corresponding cable entrances are shown on the re-
verse side of the top cover of the DS-610. Fabricate cables referring to page 2-4. Pass
the cables through their respective cable entrances and connect them to WAGO con-
nectors.
How to connect wires to WAGO connector
Press downward.
Terminal opener
Wire
Twist
WAGO connector
Procedure
1. Twist the cores.
2. Set and press the terminal opener
downward.
3. Insert the wire to hole.
4. Remove the terminal opener.
5. Pull the wire to confirm that it is secure.
Cable clamps, entrances
Top cover