1-1
1. INSTALLATION
1.1 Display Unit DS-600
Mounting consideration
The display unit can be installed on a desktop, on the underside of a table, or flush mounted in a
panel. When you select a mounting location, keep in mind the following points:
• Locate the display unit away from exhaust pipes and vents.
• Select an installation location that is well ventilated.
• Locate the display unit where shock and vibration are minimal.
• Allow enough maintenance space at the sides and rear of the display unit and leave enough
slack in cables to facilitate maintenance and servicing.
• Observe the compass safe distances (see page i) to prevent the interference to a magnetic
compass.
• The nominal viewing distance for the display unit is 1 m. Select a suitable mounting location
considering that distance.
Flush mount
See the outline drawing in the back of this manual. Before you fasten the display unit to the cutout,
first connect the cables referring to chapter 2.
1. Make a cutout in the mounting location as shown in the illustration below.
NOTICE
Do not apply paint, anti-corrosive sealant
or contact spray to coating or plastic
parts of the equipment.
Those items contain organic solvents that
can damage coating and plastic parts,
especially plastic connectors.
78 (3.07”)
12 (0.47”)
240 (9.45”)
240 (9.45”)
Pilot hole
(four places)
223+0.5 (8.78”)
223+0.5 (8.78”)
228+1 (8.98”)
(for outdoor)
228+1 (8.98”)
(for outdoor)
18 (0.71”)
18 (0.71”)
(for outdoor)
Fixing hole (4- 6)
232+1 (9.13”)
(for indoor)
232+1 (9.13”)
(for indoor)
22 (0.87”)
(for indoor)
or
