Edge Jointing
Figures 42–43
Figure 42.
Figure 43.
To edge joint on the jointer:
1.
2. Safety
Instructions Page 6
Stock Inspection & Requirement
Page 26
3.
Setting Outfeed Table Height
Page 19
4.
Note: We suggest
1
⁄16"–
1
⁄8" depth of cut for
edge jointing, and a more shallow depth for
hardwood species or for wide stock.
5.
6. ON
7.
Note: When your leading hand comes within
4" of the cutterhead, lift that push block up
and place it on the workpiece portion that is
on the outfeed table. Now, focus the down-
ward pressure with the leading hand while
feeding, then repeat the same action with
your trailing hand when it comes within 4" of
the cutterhead. Keep your hands safe! DO
NOT allow them to get any closer than 4" to
the cutterhead.
8. Step 7
