22
SETUP
Setup mode allows viewing and modifying the following parameters:
• Current Time
• Current Date
• pH Resolution
• Ion Charge
• Beep Status
• Baud Rate (serial communication)
• Command prefix (serial communication)
• Calibration Alarm Time-Out
• Instrument ID
To enter SETUP mode press SET while the instrument is in measurement mode.
Select a parameter with the ARROW keys.
Press CAL if you want to change a parameter value. The selected parameter
will start blinking.
Press RANGE to toggle between displayed parameters.
Press the ARROW keys to increase or decrease the displayed value.
Press CFM to save the modified value or CAL to escape.
Press the ARROW keys to select the next/previous parameter.
CURRENT TIME SET
Press CAL when the current time is displayed. The hour will start blinking.
Press the ARROW keys to change the hour.
Press RANGE. The minutes will start blinking.
Press the ARROW keys to change the minutes.
Press CFM to save the modified value.
Press CAL to escape without saving.
