18
Combi HP thermostatic mixer shower
T00253
Seal tight up
to shroud
drill and plug the holes.
Note: If fitting to plasterboard, use suitable
cavity fixings.
Break off the alignment tabs on the flush mount
plate (fig.36). Place a ring of silicon sealant
round the plate so that the plate seals against
the wall. Secure the plate to the wall using the
screws provided. Wipe off any excess sealant.
Fit the flush mount cover (fig.37). Locate the
lugs on the trim ring in the holes on the plate
and twist clockwise (fig.38).
Complete the fitting of your shower accessories
by referring to the appropriate section.
Shower cubicle or panel
To use the wall mounting bracket supplied with
a shower cubicle or a laminated panel, wooden
blocks are required to increase the depth of the
bracket. These blocks need to increase the depth
of the bracket to between 56 mm and 67 mm
from the finished surface (fig.44).
Decide on the shower position and whether
the hot and cold water supplies will enter the
shower from the top (falling), the bottom (rising)
or the rear.
Mark the wall for an opening of about 93 mm
diameter.
Cut the opening and offer the mounting bracket
up to the back of the panel (fig.45). Mark
the inner fixing holes and drill the panel and
wooden support blocks.
If installing a fixed head, fit the outlet adaptor
into the top outlet hole in the valve housing
(fig.16). The adaptor is sealed with an ‘O’
ring. Make sure the adaptor is fitted with the
hose end in the valve housing (fig.17). Fit the
blanking plug into the bottom outlet hole using
an ‘O’ ring to seal it.
If installing a bulkhead outlet, fit the outlet
adaptor into the bottom outlet hole in the valve
housing. The adaptor is sealed with an ‘O’ ring.
Make sure the adaptor is fitted with the hose
end in the valve housing (fig.17). Fit the
blanking plug into the top outlet hole using an
‘O’ ring to seal it (fig.18).
Make sure that the inlet elbows are facing the
T00264
9LHZIURP
EHKLQGSDQHO
0DUNERWK
KROHV
%UDFNHW
IL[LQJKROH
3ODWHIL[LQJ
KROH
Fig.43
Fig.44
Fig.45
