Step 19. Network Security (Optional)
The HP LaserJet 5Si, 5Si MX, and 5Si NX Printers allow you to lock
out other users’ ability to change most printer control panel settings.
This is done by setting a password and enabling the control panel lock.
To verify, the message ACCESS DENIED appears when you attempt to
change a setting using the printer’s control panel.
There are three ways to implement printer security:
•• From the HP LaserJet Utility for Macintosh users.
•• From the HP JetAdmin utility for NetWare networks.
•• By entering a PJL sequence from anyu DOS or Windows ASCII editor.
HP LaserJet Utility (Macintosh)
1 Select the HP LaserJet Utility icon in the HP LaserJet folder on your
hard drive.
2 If necessary, double press Select Printer to select the printer.
3 Under the Extras Menus, select Control Panel Lock.
4 In the Control Panel Lock: HP LaserJet 5Si MX screen, press the On
(Locked) box.
5 Press OK. You will be promted to enter a passwork if the password
has been set. If a passwork has not been set, go to the next step.
6 Under the Extras Menus, select Set Printer Password.
7 On the Printer Security screen, enter the new passowd (numeric nalues
can be set from 0 to 65535).
8 Press OK.
HP JetAdmin for NetWare Networks
1 Run HP JETADMIN.
2 Select the printer you want to configure in the main window. It is
listed under its "JetDirect Interface Name" on the configuration page.
Select Printer at the top of the main window.
3 Select the Security tab -- the Security Property Page appears.
4 Under Control Panel Lock, select LOCK/UNLOCK.
5
Press OK.
EN Getting Started Guide - 31
