Chapter 3.
Upgrading the Enterprise Virtual
Array to v
3.020
Upgrading from Enterprise Virtual Array v3.0xx to v3.020 involves several steps, which
must be d
one in the prescribed order. If you do not perform the upgrade process in the
appropriate order, you may not be able to manage the Enterprise Virtual Array storage system
using Command View EVA.
Note
Refer to Appendix A: Software Upgrade Flowchart for a graphical overview of the upgrade process.
Use Appendix B: Software Ve rsion Worksheet to collect important version information as you read
through this manual and perform the procedures.
HP high
ly recommends that you perform this upgrade procedure during off-peak hours. The
upgrade process may cause a fully configured HSV controller to exceed application-specific
timeout values. During the VCS upgrade, both HSV controllers reboot at the same time.
Note
Before you can perform an online upgrade to VCS v3.020, you must be running VCS v3.010 (or
later) on the HSV controllers. If you need assistance, contact an HP Authorized Service Representative.
The u
pgrade procedure contains the following steps:
29
hp StorageWorks Enterprise Virtual Array Updating Product
Software Instructions
