Commands42
NACA 0 The Normal ACA flag is 0, indicating that it is not supported.
HiSup 0 The Hierarchical Support flag is 0, indicating that the hierarchical
addressing model is not supported.
Response Data Format 2 The Inquiry Data format complies with the SCSI-3 standard.
Additional Length The length in bytes of the length of the rest of the Inquiry data.
SCCS 0 No storage array controller component is embedded in the drive.
ACC 0 No Access Controls Coordinator may be addressed through this LUN.
TPGS 01b Target Port Group Support. Only implicit asymmetric logical unit access is
supported.
3PC 0 Third-Party Copy commands are not supported.
Protect 0 Protection information is not supported.
BQue Basic Queuing flag
0 The flag is zero for SCSI drives, with CmdQue = 1.
1 The flag is 1 for Fibre Channel drives, with CmdQue = 0.
EncSvr 0 The drive does not support Enclosure Services command.
VS 0 Vendor-Specific field—not currently used
MultiP 1 The drives has multiple ports.
MChngr 0 The drive is not embedded within or attached to a medium transport
element.
Adr16 1 16-Bit Addresses are supported. The flag is only valid for parallel SCSI.
WBus16 1 Wide Bus 16 is supported. The flag is only valid for parallel SCSI.
Sync
1
Synchronous data transfer is supported. The flag is only valid for parallel
SCSI.
Linked 0 The drive does not support linked commands.
CmdQue 0 For FC drives, with BQue = 1.
1 For SCSI drives, with BQue = 0.
Vendor
Identification
A vendor-specific, 8-byte string of ASCII characters, left justified and padded
with space characters “HP”.
Product Identification A left-justified, vendor-specific, 16-byte string field of ASCII characters with
space character padding on the right. The string consists of two parts:
• First half (bytes 16–23): “Ultrium”
• Second half (bytes 24–31): “<generation>-<interface type>”
The following strings have been defined:
Gen 1 SCSI drive: “Ultrium 1-SCSI”
All Gen 2 drives: “Ultrium 2-SCSI”
All Gen 3 drives: “Ultrium 3-SCSI”
