A SERVICE OF

logo

Open as PDF
next previous
6. Remove the optical drive (see Optical drive on page 34).
7. Remove the hard drive (see {Xref Error! Target does not exist.})
8. Remove the keyboard (see
Keyboard on page 43).
9. Remove the top cover (see
Top cover on page 47).
10. Remove the system board (see
System board on page 64).
Remove the optical drive cable:
1. Release the optical drive cable from the clips built into the base enclosure.
2. Release the optical drive connector from the base enclosure by prying the clips (1) that secure
the optical drive connector to the base enclosure.
3. Remove the optical drive cable from the base enclosure (2).
Reverse this procedure to install the optical drive cable.
74 Chapter 4 Removal and replacement procedures