A SERVICE OF

logo

HotBrick Network Solutions
For each PC connected to the LAN ports, the corresponding LAN LED (either 10 or 100)
should be ON.
3. Configuring the HotBrick Load Balancer LB-2 for Internet Access
Select Primary Setup from the menu, to see a screen like the example below.
Configure WAN 1 and/or WAN 2 as required.
For any of the following situations, refer to Chapter 3: Advanced Port Setup for any further
configuration, which may be required.
Using both ports
Multiple IP addresses on either port
Multiple PPPoE sessions
PPTP connection method
Figure 8: Primary Setup Screen LB-2
13