11
45034-01 • 10/23/08 • Hunter Fan Company
Your Hunter fan comes with an integrated light xture
assembly.
WARNING: Use only the light xture supplied with this
fan model.
7-1. To attach the upper switch housing, partially
install two housing assembly screws into the
switch housing mounting plate.
7-2. Feed the upper plug connector through the center
opening of the housing.
7-3. Align the keyhole slots in the housing with the
housing assembly screws.
7-4. Turn the upper switch housing clockwise until
the housing assembly screws are rmly situated
in the narrow end of the keyhole slots. Install the
remaining screw into the housing. Tighten all three
screws rmly.
CAUTION: Make sure the upper switch housing
is securely attached to the switch housing mounting
plate. Failure to properly attach and tighten all three
assembly screws could result in the switch housing
and light xture falling.
Steps 7-1 – 7-4
Housing
Assembly
Screw
Upper
Switch
Housing
Switch
Housing
Mounting
Plate
7 • Completing Your Installation With a Bowl Light Fixture
