A SERVICE OF

logo

English-66
LUBRICATION
5. Gear lever
Remove the transmission cover, two screws.
Lubricate the joints and bearings on the left side with
an oil can.
Remove the rubber casing and lubricate the
hydrostatic transmission cable with an oil can.
Press the pedal a few times and lubricate again.
Replace the rubber cover.
Replace the transmission cover.
6. Transmission
The oil and lter should be changed by an authorised
service representative, as described in the Workshop
Manual.
7. Cutting unit
Remove the front cover.
Lubricate using an oil can:
A. The safety catch
- Joints and bearings
Lubricate using grease:
B. Interior plug
C. Groove for equipment frame
8. Drivers seat
Tilt the seat back.
Lubricate the lengthways adjustment mechanism
with the oil can.
Lubricate the lengthways adjustment runners with
grease. Pull the seat back and forth and lubricate on
both sides.
6008-209
6020-024
6020-004
8009-347