Intel Desktop Board D510MO Product Guide
36
Connecting to the S/PDIF Header
Before connecting to the S/PDIF connector, observe the precautions in "Before You
Begin" on page 23. See Figure 12, B on page 34 for the location of the S/PDIF header.
Table 8 shows the pin assignments for t
he S/PDIF header.
Table 8. S/PDIF Header
Pin Signal Name
1 Ground
2 S/PDIF out
3 VCC (5V)
Connecting to the Serial Headers
Before connecting to the serial headers, observe the precautions in "Before You Begin"
on page 23. See Figure 12, C on page 34 for the location of the serial headers.
Table 9 shows the pin assignments for the seri
al headers.
Table 9. Serial Port Headers (COM 1 and COM 2)
Pin Signal Name Pin Signal Name
1 DCD (Data Carrier Detect) 2 RXD# (Receive Data)
3 TXD# (Transmit Data) 4 DTR (Data Terminal Ready)
5 Ground 6 DSR (Data Set Ready)
7 RTS (Request To Send) 8 CTS (Clear To Send)
9 RI (Ring Indicator) 10 Key (no pin)
Connecting to the Parallel Port Header
Before connecting to the parallel port header, observe the precautions in "Before You
Begin" on page 23. See Figure 12, D on page 34 for the location of the parallel port
header.
Table 10 shows the pin assignments for the parallel port header.
Table 10.
Parallel Port Header
Pin Standard Signal Name ECP Signal Name EPP Signal Name
1 STROBE# STROBE# WRITE#
2 AUTOFD# AUTOFD#, HOSACK DATASTB#
3 PD0 PD0 PD0
4 FAULT# FAULT#, PERIPHREQST# FAULT#
5 PD1 PD1 PD1
6 INT# INT#, REVERSERQST# RESET#
7 PD2 PD2 PD2
8 SLCTIN# SLCTIN# ADDRSTB#
