SECTION 11—BATTERIES
Part No. 1122145 71 Pronto® M94™
FIGURE 11.1 Installing/Removing the Batteries
9. Connect the front battery to the controller (RED connector). Refer to FIGURE 11.2.
10. Connect the rear battery to the front battery (RED and BLACK connectors). Refer to
FIGURE 11.2.
11. Reinstall the top shroud. Refer to Removing/Installing the Shrouds on page 65.
12. Reinstall the seat. Refer to Removing/Installing the Seat Assembly on page 50.
13. Connect the joystick. Refer to Disconnecting/Connecting the Joysticks on page 42.
NOTE: New battery(ies) MUST be fully charged before using, otherwise the life of the battery(ies)
will be reduced.
14. If necessary, charge the battery(ies). Refer to Charging Batteries on page 74.
FIGURE 11.2 Installing/Removing the Batteries
Battery Lifting Straps
Battery
Terminals/Posts
Battery
DETAIL“B” - BATTERIES WITHOUT
BUILT-IN LIFTING STRAPS
DETAIL“A” - BATTERIES WITH BUILT-IN
LIFTING STRAPS
Built-in Lifting
Straps
Front
Battery
Rear
Battery
Battery
Tray
Front of Wheelchair
Rear of Wheelchair
Connector from
Battery to Controller
Front Battery
RED Front POSITIVE (+)
Battery Terminal Mounting
Screw, Nut and Fuse Hardware
(Terminal Cap Shown)
RED Rear POSITIVE (+) Battery
Terminal Mounting Screw, Nut
and Fuse Hardware*
RED Controller Connector
(Not Shown)
Rear Battery
BLACK Front NEGATIVE (-)
Battery Terminal Mounting
Screw, Nut and Fuse Hardware
(Terminal Cap Shown)
BLACK Battery
GREY Rear NEGATIVE (-)
Battery Terminal Mounting
Screw, Nut and Fuse Hardware*
Retaining Strap
*NOTE: Terminal cap shown removed for clarity.
RED Battery Connectors
Tie Wrap
Tie Wrap
