24. CAUTION-- Do not store itemsof interestto children in
cabinetsaboverange -- children climbing on the range
to reachitemscouldbe seriouslyinjured.
25. Do not touch grill andsurfaceburnerareas,perimetertrim
around cooktop or interior surfacesof oven. During and
after use,theseareasmaybe hot enoughto causeburns.
Avoid contact with these areas by clothing or other
flammablematerialsuntil they havehad sufficienttime to
cool. Other surfacesmay become hot enough to cause
burns-- amongthesesurfacesare the upperdoor frame
andglass,ovenventopeningandsurfacesneartheopening,
andthe topedge of the control panel.
26. Use care when opening oven door. Let hot air or steam
escapebeforeremovingor replacingfood.
27. Do notheatunopenedfood containers.Build-upof pressure
maycausecontainerto burstandresultin injury.
28. Always place oven racks in desired location while oven
is cool. If rack must be movedwhile oven is hot, do not
let potholdercontacthot heatingelementin oven.
29. Do not clean door gasket.The door gasket is essential
for a good seal.Careshouldbe taken not to rub,damage
or movethegasket.
30. Do not use oven cleaners. No commercial oven cleaner
or oven liner protective coating of any kind should be used
in or around any part of the oven.
31. Clean only parts listed in this manual and use procedures
recommended.
32. CAUTION: BEFORE SELF-CLEANING THE OVEN,
REMOVE BROILER PAN, FOOD, AND OTHER UTENSILS.
33. Always remove soiled broiler pan from the broiler
compartment after cooking for grease left in the pan may
become hot enough to ignite.
34. Listen for fan. A fan noise should be heard during the broil
and cleaning cycles. If not, call a serviceman before self-
cleaning again.
35. Before servicing your appliance, disconnect power to the
range at the main fuse or circuit breaker panel and at the
electrical receptacle.
36. Do not allow aluminum foil or meat probes to contact
heating elements.
37. WARNING: To reduce the risk of tipping of the appliance,
the appliance must be secured by properly installed anti-
tip devices. To check if devices are installed properly,
remove the access panel and verify that the anti-tip devices
are engaged.
