NTSC
VOLUME : 20
PHASE : 00
INPUT
SELECT
button
Items
VOLUME/SELECT button
–+
PHASE
reddish greenish
(Phase)
CHROMA
lighter deeper
(Chroma)
BRIGHT
darker brighter
(Brightness)
CONTRAST
lower higher
(Contrast)
STATUS indication
(NTSC or PAL)
00 ~ 50
–40 ~ +40
HOW TO HANDLE BASIC
OPERATIONS
BASIC OPERATION
PICTURE ADJUSTMENT
1. Press the POWER switch to turn on the power.
gON : Power turns ON. (Power indicator: lit)
GOFF : Power turns OFF. (Power indicator: unlit)
2. Press the INPUT SELECT buttons to choose input.
Select video/audio signals input to terminals on the rear
panel. The selected INPUT SELECT indicator lights in green.
3. Press the VOLUME/SELECT buttons to adjust the
speaker volume.
Press this button to display the speaker volume level on the
screen.
+ : The Built-in speaker volume is increased. (00 = 50)
– : The Built-in speaker volume is decreased. (50 = 00)
* Screen indication will disappear about 10 seconds after
operating.
1. Press select buttons corresponding to the item
you want to adjust.
The item you select is displayed on the screen.
1 PHASE ( ) : Phase control
2 CHROMA ( ) : Chroma control
3 BRIGHT ( ) : Brightness control
4 CONTRAST ( ) : Contrast control
PHASE CHROMA BRIGHT CONTRAS
POWER
ON
OFF
VOLUME/SELECT
– +
* Screen indication will disappear about 10 seconds after operating.
About the STATUS indication
● With the COLOR SYSTEM setting set
to AUTO mode, when you turn on the
power or select inputs, the colour
system indication appears for about
3 seconds on the screen while NTSC
or PAL signals are being detected.
It does not appear when receiving a
B/W signal or when no signal is input.
Refer to page 8 for more information
about COLOR SYSTEM setting and
page 9 for more information about
STATUS indication setting.
Notes:
● Phase control is effective only in the
NTSC color system mode.
● Chroma control is not effective when
receiving B/W or when no signal is
input. (Except when a component
signal is input.)
● When CHROMA is adjusted to “–40,”
the picture becomes less colourful.
● “NO EFFECT” is displayed (for about
3 seconds) when your selected
function has no effect.
2. Adjust with the VOLUME/SELECT buttons.
* When both VIDEO B terminals are connected (input) at the same time, the
Y/C terminal is given priority.
INPUT SELECT
B
A
VOLUME/SELECT
– +
7
VIDEO B terminal
VIDEO B (Y/C) terminal
Input B
(VIDEO /
Y/C)
Terminals on the rear panel
Video signal input Audio signal input
1 Input A
VIDEO A terminal AUDIO A terminal
(VIDEO)
2
AUDIO B terminal
