Diagnosing problems using EasyLED Diagnostics
LEDs in two locations on the server are available to help you diagnose problems
that might occur during installation. Use them in the following order:
1. Diagnostics panel - Look at this panel first. If a system error has occurred, the
system-error LED on the front of the diagnostics drawer is lit. Slide the latch to
the left on the front of the operator information panel to access the diagnostics
panel. Note any LEDs that are lit, and then close the drawer.
2. LEDs on the system board - To identify the component that is causing the
error, note the lit LED on or beside the component.
EasyLED LEDs
The following table describes the LEDs on the EasyLED panel and suggested
actions to correct the detected problems.
Note: Check the system-error log or IMM system event log for additional
information before replacing a FRU.
Table 15. EasyLED panel LEDs
LED Description Action
None, but the
system error
LED is lit.
An error has occurred and
cannot be isolated. The
error is not represented by
a path.
Use the UEFI Setup Utility program to check the
system error log for information about the error.
Chapter 7. Solving problems 143
