4. Press the bracket tab 3 and slide the bracket toward the
expansion-slot-opening end of the assembly until the bracket clicks into place.
5. Return to “Installing a PCI adapter” on page 56 or “Installing a PCI riser-card
assembly” on page 43, as applicable.
Removing a virtual media key
1 Virtual media key connector
2 Virtual media key (front)
3 Mounting bracket (rear)
4 Mounting tab
To remove a virtual media key, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 33.
2. Turn off the server and peripheral devices and disconnect all power cords and
external cables.
3. Slide the server out of the rack.
4. Remove the cover (see “Removing the cover” on page 37).
5. Locate the virtual media key on the system board. Grasp it and carefully pull it
off the virtual media key connector pins.
Chapter 5. Installing optional devices and replacing customer replaceable units 61
