1919
ow to use washer
H
• If the washer encounters a fault during
operation, the associated fault will be
displayed.
“ ” : Water pressure sensing error
“ ” : Problem of overfilling water
“ ” : Door is not closed
“ ” : Over load in motor.
“ ” : Over load in motor.
“ ” : Water inlet trouble
“ ” : Drainage trouble
“ ” : Unbalanced load
“ ” : Water temperature trouble
“ ” : Dry heater or thermostat
trouble
If these error letters are displayed, please
refer to the troubleshooting page26 and
follow the guide.
DISPLAY
• When child lock is selected, the
“ ” is displayed.
• When time delay is selected, it shows
the remaining times to finish the selected
program.
• When washing cycle is completed,
“ ” is displayed on the “Multi
display”.
• During washing cycle, the remaining
washing time is displayed.
• Recommended program by
manufacturer.
[WASH]
- SANITARY : Approx. 1 hour and 37 minutes
- COTTON : Approx. 1 hour and 22 minutes
- PERM. PRESS : Approx. 1 hour and
17 minutes
- WOOL/SILK : Approx. 56 minutes
- RINSE+SPIN : Approx. 32 minutes
[WASH/DRY]
- SANITARY : Approx. 4 hours and 46 minutes
- COTTON : Approx. 4 hours and 31 minutes
- PERM. PRESS : Approx. 4 hours and
25 minutes
- RINSE+SPIN : Approx. 3 hours and
41 minutes
• The washing time may vary by the
amount of laundry, water pressure,
water temperature and other washing
conditions.
• If an unbalanced load is detected or if
the suds removing program operates,
the wash time may be extended.
(Max. increasing time is 45minutes.)
1. Special function display
3. Completion of washing
4. Time left
2. Self diagnose display
