A SERVICE OF

logo

Open as PDF
next previous
8
Finger Tighten Hardware
AM
AM
WARNING
Do not overtighten the Cap Nut. If the end of
the Bolt breaks through the plastic cap, call our
Customer Service Department at the number
on Page One. Exposed threads on the end of
the Bolt may cause serious injuries.
Opt. 2.11: Attach a Gutter Channel (AB) (Truss Support Strips (AM) t inside Gutter Channel (AB)). Attach
Truss Channel (AD) to Gutter Channel (AB) at each end.
AB
AB
AB
AM (x2)
FB
FC
FB
FC
Tighten All Hardware
Opt. 2.12: Attach Truss Assembly to two Wall Support Channels (AC). Do not completely tighten the Cap Nut
(FC) until after truss is secured to the wall.
AC
FB
FC
Use Second
Holes from
the end.
AB
AC
FD
FB
FC
AB
AB
AM
Opt. 2.10: Fit two Truss Support Strips (AM) together. Bolt Truss Support Strips (AM), Center Gutter
Connector (FD) and two Gutter Channels (AB). Refer to the Owner’s Manual that came with your shed when
assembling other truss frames.