A SERVICE OF

logo

Open as PDF
next previous
9
Note: As new panel slides into place be sure that screw bosses along the sides interlock
properly with the adjoining Wall Panels.
1
2
1. Set Wall Panel Tabs into Floor Panel Slots.
2. Slide Wall Panel to the left until the Wall Panel locks into place.
3. Use a Rubber Mallet to nudge the panel into position. Be careful
not to damage the edge of the wall panel.
3
Opt. 2.13: Replace the two Wall Panels that were previously removed. Add the two new Wall Panels that came
with this kit.
Opt. 2.14: Replace the Truss assembly that was previously removed. Add the new Truss assembly from steps
2.9 to 2.11.