4
1. Please Observe the following
1.1 Emphasized Sections
Warning!
Refers to safety regulations and requires safety measures that protect the operator or other persons from injury or
danger to life.
Notice
Gives recommendations for better handling of the unit during operation or adjustment as well as for service
activities.
1.2 For Your Safety
For safe and successful operation of the unit, read these instructions completely. If the instructions are not observed,
the manufacturer can assume no responsibility. Retain this manual for future reference.
Warning!
Always wear goggles and heat resistant gloves rated to 400°F (205°C) when operating system.
Warning!
Observe general safety regulations for the handling of chemicals such as Loctite® adhesives and sealants. Observe
the manufacturer’s instructions as stated in the M
aterial Safety Data Sheet (MSDS).
Properly ventilate equipment according to appropriate MSDS for the hot melt adhesive used.
Warning!
Do not mix hot melt formulations in the melt tank. To change formulations, purge and clean tank with materials
recommended by the adhesive manufacturer at the recommended temperature.
Warning!
In the event of malfunction turn off power to the equipment at the circuit breaker of the melt unit and remove power
source to the unit at the nearest main disconnect.
Warning!
Do not use flammable material.
Notice
While under warranty, the unit may be repaired only by an authorized Henkel service representative.
Notice
Henkel Corporation has designed this equipment for safe operation. However, heated thermoplastics and other hot
melt materials are dangerous and care must be exercised to ensure operational safety. Handling must be in
accordance with hot melt adhesives manufacturer specifications.
Notice
Dispose of hot melt adhesives properly. Refer to the Materials Safety Data Sheet (MSDS) of the hot melt for
recommended disposal methods.
