Maxtor DiamondMax 17 80-160GB AT Hard Disk Drive 2-3
General Description
Reliability
– 550k hours mean time expected until failure (MTTF)
–Automatic retry on read errors
– 320-bit, non-interleaved Reed-Solomon Error Correcting Code (ECC), with
cross checking correction up to fifteen separate bursts of 10 bits each totalling up
to 150 bits in length
– S.M.A.R.T. 4 (Self-Monitoring, Analysis and Reporting Technology)
–Transparent media defect mapping
–High performance, in-line defective sector skipping
–Reassignment of defective sectors discovered in the field, without reformatting
– Shock Protection System to reduce handling induced failures
–Data Protection System to verify drive integrity
–Quiet Drive Technology
2.1 REGULATORY COMPLIANCE STANDARDS
Maxtor Corporation’s disk drive products meet all domestic and international product
safety regulatory compliance requirements. Maxtor’s disk drive products conform to
the following specifically marked Product Safety Standards:
–Underwriters Laboratories (UL) Standard 1950. This certificate is a category
certification pertaining to all 3.5-inch series drives models.
–Canadian Standards Association (CSA) Standard C.22.2 No. 1950. This certificate
is a category certification pertaining to all 3.5-inch series drives.
– TUV Rheinland Standard EN60 950. This certificate is a category certification
pertaining to all 3.5-inch series drives models.
–Korean EMC certifications are issued by Radio Research laboratory (RPL), which
is organized under the Ministry of Information and Communications (MIC).
EMC testing includes electromagnetic emissions (EMI) and susceptibility (EMS).
Certified equipment is labeled with the MIC mark and certification number.
Product EMI/EMS Qualifications
–CE Mark authorization is granted by TUV Rheinland in compliance with our
qualifying under EN 55022:1994 and EN 50082-1:1997.
–C-Tick Mark is an Australian authorization marked noted on Maxtor’s disk drive
products. The mark proves conformity to the regulatory compliance document
AS/NZS 3548: 1995 and BS EN 55022: 1995.
–Maxtor’s disk drives are designed as a separate subassembly that conforms to the
FCC Rules for Radiated and Conducted emissions, Part 15 Subpart J; Class B
when installed in a given computer system.
–Approval from Taiwan BSMI. Number: D33019
