A SERVICE OF

logo

Open as PDF
next previous

28
WARNING!
Lead-acidbatteriesgenerate
explosivegases.Keepsparks,
ameandsmokingmaterials
awayfrombatteries.Always
weareyeprotectionwhenaround
batteries.
WeakBattery
If your battery is too weak to start the engine, it should
be recharged. (See Battery in the Maintenance
section.)
If “jumper cables” are used for emergency starting,
follow this procedure:
JumperCables
Connect each end of the RED cable to the 1.
POSITIVE (+) terminal on each battery, taking
care not to short against chassis.
Connect one end of the BLACK cable to the 2.
NEGATIVE (-) terminal of the fully charged
battery.
Connect the other end of the BLACK cable 3.
to a good CHASSIS GROUND on the mower
with the discharged battery, away from the fuel
tank and battery.
Toremovecables,reverseorder
Remove BLACK cable rst from chassis and 1.
then from the fully charged battery.
Remove RED cable last from both batteries.2.
IMPORTANTINFORMATION
Yourmowerisequippedwitha12-volt
negativegroundedsystem.Theothervehicle
mustalsobea12-voltnegativegrounded
system.Donotuseyourmowertostartother
vehicles.
8011-642
Jumper cable connection