203
Controls in detail
Transfer case
Switching LOW RANGE mode off
(switching from LOW RANGE to HIGH
RANGE)
̈ Press LOW RANGE switch 1
(
୴ page 202).
Indicator lamp 2 flashes.
If the system senses that all conditions
are met, it will switch to back to
HIGH RANGE mode. A chime sounds
and the LOW RANGE display 3 ap-
pears in the multifunction display.
The indicator lamp 2 on the
LOW RANGE switch goes out, indicat-
ing that the LOW RANGE mode has
been deactivated.
For messages in the multifunction display,
see “Practical hints” section (
୴ page 488).
i
You can cancel the procedure by pressing
the LOW RANGE switch again while the indicator
lamp is flashing.
!
The shift procedure can only be performed
when the following conditions are met:
ț The engine is running (୴ page 41).
ț The automatic transmission is in position N
(
୴ page 190).
ț The vehicle speed does not exceed 43 mph
(70 km/h).
i
There is no reset to LOW after the ignition
has been switched off.
i
You can cancel the procedure by pressing
the LOW RANGE switch again while the indicator
lamp is flashing.
164.boo Seite 203 Freitag, 30. März 2007 12:54 12
