21
APPENDIX A: HMS-10 ACCESSORIES
The following HMS-10 accessories are available from Meyer Sound.
NOTE: Belden 1502 is a composite cable comprised of two 18 AWG wires for DC power, two 22 AWG wires
for balanced audio, and one 24 AWG wire for the audio shield. This single cable can deliver both DC power
and balanced audio to loudspeakers at cable runs of up to 150 feet with only 1 dB of loss in peak SPL. Longer cable
runs are possible with heavier gauges for DC power and separate cables for balanced audio. For more information,
see “HMS-10 Current Draw and Cable Requirements” on page 15.
HMS-10 Accessories
Part Number Accessory Notes
09.183.001.01
MPS-488P external power supply with U.S. power cord
Powers up to four HMS-10s; connect only to channel
outputs 1, 3, 5, and 7
09.183.001.02
MPS-488P external power supply with CE power cord
Powers up to four HMS-10s; connect only to channel
outputs 1, 3, 5, and 7
420.027
MPS-488 Fuse Replacement
2-amp, 250-volt slow-blow fuse (T2A-250V)
484.065 Phoenix 5-pin female cable mount connector Connects to MPS-488
P channel output connectors
and HMS-10 loudspeaker connectors
524.014 1502R (regular) bulk cable 500-ft spool, no connectors
524.015 1502P (plenum) bulk cable 500-ft spool, no connectors
