23
APPENDIX B: HMS-10 CABLE ASSEMBLY
ASSEMBLING PHOENIX-TO-PHOENIX LOUDSPEAKER CABLES
To connect the HMS-10 loudspeaker directly to the MPS-488P power supply, you need a Phoenix 5-pin female to Phoenix
5-pin female cable. The following procedure documents how to assemble this cable.
To assemble a Phoenix-to-Phoenix cable:
1. If the cable has not yet been stripped, strip one end of the cable. Strip the outer shielding by 1” and then strip the black,
red, blue, and white wires by .275”.
2. Insert the five exposed conductors, from one end of the cable, into the five cable holes in one of the Phoenix connectors.
Use the following wiring scheme.
Assembled Phoenix-to-Phoenix Cable
Phoenix 5-Pin Female Cable Mount Connector
Pin #1 Black 48 V DC (–)
Pin #2 Red 48 V DC (+)
Pin #3 Shield Audio shield
Pin #4 Blue Audio (–)
Pin #5 White Audio (+)
Connector side upSide (cable attached)
