MANUAL TRANSMISSION (E-W) -
Center Differential <W5M42>
22B-16-2
A
B
"
TAPER ROLLER BEARING REMOVAL
Use the special tools to remove the taper roller bearing.
REASSEMBLY SERVICE POINTS
"
A
A
TAPER ROLLER BEARING INSTALLATION
Use the special tool to install the taper roller bearing.
"
B
A
TAPER ROLLER BEARING INSTALLATION
Use the special tools to install the taper roller bearing.
"
C
A
SPACER/SIDE GEAR/WASHER/PINION/PINION
HOLDER/PINION SHAFT/LOCK PIN/FRONT
OUTPUT SHAFT/SNAP RING/CENTER
DIFFERENTIAL FLANGE INSTALLATION
(1) Install the side gear in the center differential case with
the spacer attached.
NOTE:
If a new side gear is to be installed, select a spacer with
medium thickness (0.93 - 1.00 mm).
(2) Fit the washer on the back of each pinion. Engage the
4 pinions simultaneously in the side gear.
Rotate the gears to place them in position, then install
the pinion shaft holder.
(3) Insert the pinion shafts.
(4) Install th e lock pins in the illustrated direction.
PWEE9508-E
E
Jun. 1998Mitsubishi Motors Corporation Added
MD998917
MD990930
MB990937
MD998812
MD998823
Lock pin
Differential case
Pinion shaft
