54
Features That Can Be Set Using the Multi Selector
Shooting Features
Using the Flash (Flash Modes)
The flash mode can be set to match the shooting conditions.
1 Press the multi selector H (m flash mode).
2 Press the multi selector H or I to choose the
desired flash mode and press the k button.
• See “Available Flash Modes” (A 55) for more
information.
• If a setting is not applied by pressing the k button
within a few seconds, the selection will be canceled.
• When U (auto) is applied, D is only displayed for
a few seconds, regardless of Photo info settings
(E 64).
3 Frame the subject and take a
picture.
• The flash lamp indicates flash status when
the shutter-release button is pressed
halfway.
- On: The flash will fire when you press
the shutter-release button all the way down.
- Blinks: Flash charging. Wait a few seconds and try again.
- Off: Flash will not fire when picture is taken.
• If the battery is low, the monitor will turn off, and remain off, while the flash charges.
C Effective Range of the Flash
When ISO sensitivity is set to Auto, the flash has a range of 0.3–4.5 m (1 ft–14 ft) at the maximum
wide-angle zoom position and a range of 0.5–3.5 m (1 ft 8 in.–11 ft) at the maximum telephoto
zoom position.
Flash mode
