Oreck FC1000 Manual

A SERVICE OF

next previous

20

• If there is no blockage in the hose. Remove the power

nozzle from wand and attach wand to hose. Check for

suction and remove any blockages.

Nozzle Blockage

• If the nozzle becomes clogged, use the following

procedures to check for and clear the blockage.

• If blockage is severe enough the nozzle will shut

off. After the blockage is cleared you must push the

Overload Protection Reset button (A) before the

nozzle will operate again.

• Make sure power nozzle is disconnected from wand.

Then check for blockage in nozzle connection (B).

• There is an additional panel on the bottom of the

nozzle (C). This opening provides a secondary place

to check and clear blockage.

Maintenance

- continued