System Programming 4-29
4.2 System Programming [207]-[208]
Assigns the maximum time allowed between digits for an outgoing outside call.
Default 20 seconds
• The interdigit timer applies until the call barring check is completed. When the timer
expires, an outgoing outside call will be disconnected while dialling, if “Enable” was
selected in program [211] “No Dial Disconnection”.
• For a single line telephone, an outgoing outside call will be released from a DTMF
receiver when the interdigit timer expires.
• Feature Reference
Section 3, Features
Call Barring
[208] Interdigit Time
(5/10/15/20 sec)
☞
Sets the hookswitch recall time range sent from an extension to the system.
MODE 1: 50 to 180 milliseconds.
MODE 2: 80 to 180 milliseconds.
MODE 3: 80 to 650 milliseconds.
MODE 4: 80 to 1000 milliseconds.
MODE 5: 200 to 1000 milliseconds.
Default MODE 1
• Feature Reference
Section 3, Features
Recall Button on a Single Line Telephone
[207] Recall Timing Range Selection
(MODE1/MODE2/
MODE3/MODE4/
MODE5)
☞
!
!
PSQX1708ZA-08E.QX 99.10.15 1:01 PM Page 29
