Command Protocol Reference Guide
A - 47
Description
This parameter enables or disables exit tone generation for the telephony
interface. If exit tones are enabled (1), then an exit tone is played whenever the
auto-hangup feature engages and disconnects the telephony interface. Entry
tones (see the phone_entry_tone_en parameter) and exit tones are typically
enabled to prevent a caller from entering or exiting a conference unannounced.
phone_flash Connect Or Disconnect Telephony Interface
Description
Setting this parameter disconnects the telephony interface then reconnects it
after a short delay. The amount of delay can be configured with the
phone_flash_delay parameter.
Examples
phone_flash_delay Set Flash Delay
Argument Argument value
Channel Type Virtual Channel
Value Type Void
Read/Write Mode Write-Only
Phys Chans Analog Telephony Output
Virt Chans Mono
Command Response Description
set phone_flash "Phone
Out"
val phone_flash "Phone
Out"
Flashes the phone interface associated with the virtual
channel "Phone Out" to -6dB. Note that the phone out
virtual channel name must be used, not the phone in
virtual channel name.
Argument Argument value
Channel Type Virtual Channel
Value Type Integer
Read/Write Mode Read/Write
Phys Chans Analog Telephony Output
Virt Chans Mono
