8
Installation
Installation
INSTALLATION TIPS
Although the solar transmitters for the ane-
mometer, outdoor thermo/hygro sensor, and
rain gauge contain a built-in Ni-MH battery,
they also require a backup battery. See the
assembly sections in this manual for instruc-
tions on installing a backup battery in those
components. Replace the backup battery for
these components once a year or
when appears under the corresponding
sensor’s window.
The weather station operates at 433 MHz
and does not require wire installation among
the component parts. To ensure successful
installation and the best performance, we
recommend you follow the preparation,
installation, and connection instructions in
the order they appear in this manual.
1. Select the best location for each
weather station component and carefully
measure the approximate mounting dis-
tances.
2. Make sure you have all the tools/sup-
plies necessary to install each compo-
nent.
3. Assemble and calibrate the anemome-
ter. See “Calibrating the Anemometer”
on Page 9.
MEMORY
control Press the desired mode (such as outdoor temperature), then press
MEMORY
to view the saved high/low value.
ALARM
control Press the desired mode (such as outdoor temperature), then press
ALARM
to see the desired alarm condition(s).
SET
control Press to store a setting in memory.
UNIT
control Press to toggle among various units of measurement.
alarm on/off Repeatedly press to turn the desired alarm condition on or off.
up Press to increase a value.
down Press to decrease a value.
Icon/
Control
Description Function
Weather
Monitor
Typical Installation
Station
Rain Gauge
Anemometer
Thermo/Hygro
Sensor
Solar Transmitter
Transmitter
Rain Gauge
Anemometer
Solar Transmitter
Thermo/
Sensor Solar
Hygro
