Regency E21 Gas Fireplace Insert
Run the wire through the right or left side
inlet opening. Be careful not to damage the
Note: We recommend a maximum of 15'
of wire but if you wish to go with a
longer run, use the Thermostat Wire
Connect the wire to the supplied wall switch
and install into the receptacle box.
Use the Regency Remote Control Kit approved
for this unit. Use of other systems may void
The remote control kit comes with a hand held
transmitter, a receiver and a wall mounting
Choose a convenient location on the wall
to install the receiver and the receptacle
box (protection from extreme heat is very
important). Run wires from the fi replace to
that location. Use Thermostat Wire Table.
Connect the two wires to the gas valve. See
Install 3 AAA alkaline batteries in transmitter
and 4 AA alkaline batteries in the receiver.
Install the receiver and its cover in the wall.
Switch the remote receiver to "remote"
mode. The remote control is now ready for
A wall thermostat may be installed if desired,
connect the wires as per the wiring diagram.
Use table below to determine the maximum
Note: Preferable if the thermostat is
installed on an interior wall.
Regency offers an optional programmable
thermostat but any 250-750 millivolt rated non-
anticipator type thermostat that is CSA, ULC or
H
I
L
O
O
F
F
O
N
P
I
L
O
T
TP
TH
To
wall
switch,
remote
control
or
thermost
at
To
thermopile
THTP
Recommended Maximum Lead Length
(Two-Wire) When Using Wall
