31
NO ACTION ### DWELL OPT
EDIT GROUP 1
CANCEL
[FAR : EDIT :END]
4. Configure each ACTION, ###, DWELL, and OPT.
In the sample screen on the left, ACTION #1 is the
command for the PTZ camera to go to PRESET #1 using
the PRESET speed of 360 as programmed in the PRESET
SETUP menu (see page 26), and stay at that position for 3
seconds before moving to the next action.
5. After setting up an ACTION, use the NEAR key to move the
cursor to
the NO column, and then move the cursor up and
down to select another ACTION to configure or modify.
6. After setting up all the ACTIONs for this GROUP, press the
FAR key to exit. At
this point, the cursor will move to SAVE.
Press the NEAR key to save the data.
NO ACTION ### DWELL OPT
EDIT GROUP 1
CANCEL
[▲▼:CHANGE VAL.]
NO ACTION ### DWELL OPT
EDIT GROUP 1
CANCEL
From SPEED DOME CAMERA
SYSTEM INITIALIZE
EXIT
This menu lets the user clear selected programmed data, clear all
programmed data, or reboot the entire camera or system.
CLEAR ALL DATA
Deletes all user-programmed data including
DISPLAY SETUP, CAMERA SETUP, and
• CLR DISPLAY SET
Clears the DISPLAY SETUP data and initializes
the configuration of that data.
• CLR CAMERA SET
Clears the CAMERA SETUP data and initializes
the configuration of that data.
• CLR MOTION SET
Clears the MOTION SETUP data and initializes
the configuration of that data.
• CLR EDIT DATA
Deletes all PRESET SETUP data, SWING SETUP
data, PATTERN SETUP data, and GROUP
Reboots the zoom camera module.
Reboots the entire PTZ camera.
