Page 11 of 12 2475SDB - Rev: 1/21/2014 7:58 AM
Other electrical devices,
such as computers,
televisions, or power
strips, may be absorbing
In-LineLinc is taking a
long time to respond
to a controller.
sending commands to a
responder that is no
longer in use. Commands
for the unused responder
are being resent and
Unlink any unused responders from the controller.
HINT: If you are using home automation software,
you can easily check scene membership and
eliminate unnecessary links.
If the above doesn’t work, perform a factory reset
on the controller.
The load turned on by
itself.
Another controller or timer
could have triggered In-
Perform a factory reset. See Resetting In-LineLinc
to its Factory Default Settings.
off In-LineLinc but In-
LineLinc does not turn
on when I send an ON
command from the
In-LineLinc may be linked
at its off state.
Re-link In-LineLinc to the controller, while the load
is on. See Linking an INSTEON Controller to In-
LineLinc.
In-LineLinc is locked
up.
A surge or excessive
noise on the power line
may have glitched it.
Temporarily remove power from In-LineLinc,
usually by opening the breaker feeding it.
If the above doesn’t work, perform a factory reset.
See Resetting In-LineLinc to its Factory Default
If you have tried these solutions, reviewed this Installation and Programming Guide, and still cannot
resolve an issue you are having with In-LineLinc, please call:
The INSTEON Gold Support Line
800-762-7845
Certification and Warranty
Certification
This product has been thoroughly tested by ITS ETL SEMKO, a nationally recognized independent third-party testing laboratory. The North American
ETL Listed mark signifies that the device has been tested to and has met the requirements of a widely recognized consensus of U.S. and Canadian
device safety standards, that the manufacturing site has been audited, and that the manufacturer has agreed to a program of quarterly factory follow-
up inspections to verify continued conformance.
FCC & Industry Canada Compliance Statement
This device complies with FCC Rules Part 15 and Industry Canada RSS-210 (Rev. 8). Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux
conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le
fonctionnement.
