Page 5 of 12 2475SDB - Rev: 1/21/2014 7:58 AM
2) At the circuit breaker or fuse panel, disable the circuit supplying power to the fixture, and then verify
the power is off
3) Remove the wallplate from the fixture you’ll be replacing. Then, unscrew the fixture itself and pull it
out from the junction box.
4) Disconnect the wires from the fixture you will be controlling and ensure that you have ½ inch of bare
wire on the ends.
5) See the diagram below to identify and connect the LINE, LOAD, NEUTRAL, and GROUND wires on
In-LineLinc. Be sure you have correctly identified the wires in the junction box before connecting
them.
Wiring Diagram
NOTE: Home’s wire color and wire location may vary
6) After you have connected all the wires, ensure that the wire connectors are firmly attached and that
there is no exposed copper except for the GROUND wire
7) Prior to reinstalling the fixture, turn on circuit breaker supplying power to the fixture
8) Use the On and Off buttons on In-LineLinc to test that it is controlling the load
9) Link In-LineLinc to the desired INSTEON devices. See
Adding In-LineLinc to a Scene as a
Responder.
10) Gently place In-LineLinc into the junction box, making sure nothing could accidentally press any of
the buttons on its face
11) Reinstall the fixture
