![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/6/7c/67caea51-82ae-4b23-af37-20d3aee0ffa0/67caea51-82ae-4b23-af37-20d3aee0ffa0-bg20.png)
If red light on sensor/motion detec-
tor stays on during installation:
Press [CODE] then press [TEST]. If it
still
stays on, remove the battery, wait
a few seconds, then replace the bat-
tery. Press [CODE] then press
[TEST]
again.
If the “ARMED” indicator is
flash-
ing:
This indicates that there has been an
intrusion. Also, if a zone indicator is
on, this indicates which zone was vio-
lated. To turn the zone indicator off,
and stop the armed indicator from
flashing, press the
[LIGHT
ON] or
[LIGHT OFF] button on the remote
control. If a zone indicator is not on,
the violated zone will have been one
of the second eight zones. Press (BY-
PASS] to see which zone
was
tripped.
If the POWERHORN does not trip
when the alarm trips:
Note: The POWERHORN will not
start to sound until the lights (connect-
ed to Lamp Modules and
Wall
Switch
Modules) have flashed on and off
about 5 times.
l
Be sure you set the Housecode on
the
POWERHORN
to the same let-
ter as the Console.
l
Plug the
POWERHORN
into anoth-
er outlet near the Console.
If the motion detector causes “false
alarms”:
l
All
brands of motion detectors
sense motion by detecting a change
in temperature, therefore do not
32
place the motion near any sources
of heat such as over an air condi-
tioning or heating vent.
l
Do not place in a direct source of
bright light’ such as sunlight..
If the Console doesn’t dial out:
l
Check that you have programmed
in a phone number (see page 15).
If the Console doesn’t play back any
message when the phone is an-
swered:
o
Check that you have programmed
in a message (see page 15).
If the Motion Detectors arm when
you press ARM HOME on the
SH624 Remote Control.
l
Check that you are using the newer
version Motion Detector
(SP554A).
The
older
version
(SP554)
wilt not
work with the ARM HOME/ARM
AWAY feature of the
SH624.
If the Console appears to be
“locked-up”
If the BUSY light is on, you may
have just switched the Console
from INSTALL to RUN. The Con-
sole will then play back the 15 sec-
onds of
pre-recorded
message. If
you don’t have the earpiece con-
nected you might think that the
Console is locked-up. Just wait for
15 seconds and the BUSY light will
go out’
If the BUSY light is not on but the
Console appears to be locked-up
you might have just tested the sys-
tem. When the Console dials out,
Smarthome.com, Inc. (800) SMART-HOME (949) 221-9200 http://smarthome.com