Page 5-5
SPIRE III Series – Installation and Operating Instructions
sHaFt storaGe cradle
Figure 13. Shaft Storage Cradle on Back of the Laminator.
Use Shaft Storage Cradles to store shafts that are
not in use.
pull rollers and cHIll Idler
(44t, 64t)
Figure 14. Pull Rollers and Chill Idler.
Shown from rear.
WARNING: Keep your hands and ngers
away from the point between the two Main
Rollers (nip point) and Pull Rollers. Do not operate
when alone. More than one person is required to be
in the area when operating. Failure to observe this
warning could result in severe personal injury.
If entrapment between the Main or Pull Rollers
occurs, use an Emergency Stop Switch.
Emergency Stop Switches
The Emergency Stop Switches are located on all
four upper corners of the machine.
Pull Rollers raise and lower with the Main Rollers by
turning the Gap/Pressure Crank.
a pull rollers (44t, 64t)
The Pull Rollers are motor driven and are located at
the back of the laminator. The rollers pull the lm and
image through the laminator.
c. cHIll Idler
The Chill Idler is located between the Main and Pull
Rollers. While lm or media is exiting through the
Main Rollers, the Chill Idler cools the media as it
exits the Main Rollers.
coolInG Fans (44t, 64t)
Located behind the Main Rollers, the fans cool the
web as it exits the heated rollers.
Figure 15. Cooling Fan Ports.
Shown from rear; Pull Roller in foreground.
