Page 5-11
SPIRE III Series – Installation and Operating Instructions
a. roller Heater temperature
d
Isplay
Displays the lower heater setpoint temperature. If the
Lower IR sensor is blocked, the alarm sounds and
the display ashes until the obstruction is resolved
and the MEASURE button is pressed. Refer to “IR
Sensor” and “Clear a Film Jam (Wrap-Up)” sections.
When the laminator is set to Fahrenheit, the °F LED is
illuminated and when the laminator is set to Celsius,
the °C LED is illuminated.
B. roller Heater temperature
I
ncrease and decrease Buttons
Press the Increase or Decrease button one time to
increment the temperature setpoint by 1 degree.
Press and hold to change the temperature rapidly.
c. Heat on and oFF Button
Press to turn on the heat. The Temperature displays
the setpoint temperature. Press again to turn off the
heat
d. measure Button
Press to display the actual temperature of the roller.
The value displays for 10 seconds.
model 64ct control panel
elements
The 64Ct models include items A through C, E, F,
(Figure 27) and the following.
B
C
D
A
Figure 29. 64Ct Control Panel Elements.
a. loWer roller Heater temperature
d
Isplay
Displays the lower heater setpoint temperature. If the
Lower IR sensor is blocked, the alarm sounds and
the display ashes until the obstruction is resolved
and the MEASURE button is pressed. Refer to “IR
Sensor” and “Clear a Film Jam (Wrap-Up)” sections.
When the laminator is set to Fahrenheit, the °F LED is
illuminated and when the laminator is set to Celsius,
the °C LED is illuminated.
B. loWer roller Heater temperature
I
ncrease and decrease Buttons
Press the Increase or Decrease button one time to
increment the temperature setpoint by 1 degree.
Press and hold to change the temperature rapidly.
c. loWer Heat on and oFF Button
Press to turn on the heat. The Temperature displays
the setpoint temperature. Press again to turn off the
heat
d. measure Button
Press to display the actual temperature of the roller.
The value displays for 10 seconds.
