GB
6
Important
INSTALLATION AND SETUP SHOULD
BE CARRIED OUT BY AN AUTHORISED
TECHNICIAN ACCORDING TO
CURRENT INSTALLATION STANDARDS.
Positioning the hobs
Depending on the model to be installed, an
opening with the dimensions shown in
figure 1 should be cut into the unit's work-
top.
The system for fixing the hob is intended
for use with kitchen units with a thickness
of 20, 30 and 40 mm.
A shelf should be placed inside the kitchen
unit; there should be a minimum distance
of 20 mm between the lower part of the
hob and the upper part of the shelf.
The hobs described in this manual can
only be installed with TEKA brand ovens.
The minimum distance between the cook-
ware support surface and the lower part of
the kitchen unit or the hood located above
the hob should be at least 650 mm. If the
hood's installation instructions recommend
that the distance is greater than this, you
should follow this advice.
The unit where the hob and oven will be
located should be suitably fixed.
Warnings:
When hobs are handled before
being installed, care should be taken in
case there is any protruding part or
sharp edge which could cause injury.
When installing units or applian-
ces above the hob, the hob should be
protected by a board so that the glass
Installation
fig. 1
Minimum distance
to walls
Minimum ventilation
distances
Fitting holes
Mod.: CGX 60 4G IS
Mod.: CGX 70 5G IS TR
5
7
5
m
a
x
.
W
L
The dimensions L and W are in the table
"Dimensions and characteristics" in the Technical
Information section.
5
7
5
m
a
x
.
W
L
