7
cannot be damaged by accidental
blows or heavy weight.
If the glass breaks or cracks, the
hob should immediately be disconnec-
ted from the electric current in order to
avoid the risk of electric shock.
The glues used in manufacturing
the kitchen unit and on the decorative
laminates and on the laminates that are
part of the worktop surface should be
made to tolerate temperatures of up to
100ºC.
TEKA does not assume any res-
ponsibility for any malfunction or
damage caused by faulty installation.
PLEASE REMEMBER THAT THE GUA-
RANTEE DOES NOT COVER THE
GLASS IF IT SUFFERS A VIOLENT
BLOW OR IF IT IS USED IMPROPERLY.
Positioning the oven
Please see the corresponding
manual.
Fixing the hob
When the gap has been properly sized,
the gasket (A) should be put on the lower
side of the hob. Place the clips (D) as indi-
cated in figure 2, fastening them to the
holes of the lower part of the body by using
the self-tapping screws provided (Ø 4,2
mm).
If the thickness of the kitchen unit is equal
to or less than 30 mm, use the self-tapping
screws that are provided as a fastening
accessory by putting them into the clip's
round hole. This hole will be threaded as
the screw is inserted into it, which should
be done before fixing the clip to the hob.
Note: It is essential that the gasket be
placed under the brim of the hob.
Failure to install it may cause the work-
top to be exposed to high temperatures.
Connecting the gas
The gas exit pipe of the hob should be
connected to the gas mains according to
installation standards or regulations in
force and it should be done by qualified
technical staff (an authorised installer).
Since it is an immobilised appliance, the
gas connection for these hobs must be
done using rigid piping for hobs to be used
in the EC. The hob comes with a ½" dia-
meter threaded connection as per EN ISO
228-1 or a ½" taper threaded connection
as per EN 10226-1, in accordance with the
regulations of the country where the hob is
to be used.
The gas exit pipe of the hob should be
connected to the gas mains following
basic guidelines for the installation of gas
in inhabited buildings
TEKA does not assume any responsibility
for any malfunction or damage caused by
incorrect or faulty installation.
To avoid damaging the hob when tighte-
fig. 2
Gasket
Hob
Screw
Clip
20 mm
30 mm
40 mm
