Example:
You want to cook at power level 6 on an
induction cooking area and begin with
rapid heating.
Select power 9, touch the sensor again
and A will come on, and then come down
to power level 6 using the sensor. The
system keeps the hotplate at power 9
(maximum) for 460 or 120 seconds
(depending on the model), flashing alter-
nately between 6 and A, after which time
the cooking level continues at 6 automati-
cally.
MODIFYING THE POWER LEVEL
DURING HEAT-UP
1 The selected hotplate must have already
been enabled. The corresponding deci-
mal point must be lit (11).
2 Use the sensor (2, or 5 in models
...640 and ...644) to change the power
level.
When increasing the power using the
sensor (2, or 5 in models ...640 and
...644) the time that has already elapsed is
taken into account.
Example:
You are cooking and you have chosen
level 1 power (48 seconds burst of coo-
king) and after 30 seconds change it to 4
(312 seconds). The remaining time of the
bust of cooking will be 282 seconds (312
minus 30).
Heat-up time will be discontinued on
induction hotplates if the pan is remo-
ved. If a pan is put back within the pan
detection time (10 minutes) the heat-up
time that remained will recommence.
With induction hotplates, heat-up cannot
be enabled if the Power function is ena-
bled.
SWITCHING HEAT-UP FUNCTION OFF
When at least 10 seconds have elapsed
since heat-up function was enabled:
1 Select the hotplate. The decimal point
(11) is lit.
2 Touch the sensor (4).
The heat-up function is automatically disa-
bled and the hotplate remains at the cons-
tant cooking level.
The Power function
(Concentrated power)
except ...604 model
Up to 3.200 watts can be concentrated in
the induction cooking areas using the
Power function (see values marked * in the
presentation section).
1 Select the desired cooking area, the
decimal point (11) will come on.
2 Next touch the Power sensor or
(6). The power level display will show
the symbol P.
The maximum duration of the Power func-
tion is 10 minutes. When this time elapses,
the power level will automatically adjust to
power level 9.
Each side of the hob has an induction
generator that works with a maximum
power or 3,600/3,700 watts. Therefore, the
Power function cannot be activated at the
same time in two heating elements that
are on the same side. In other words, if
this function is working on a heating ele-
ment on the left, the Power function can
GB
26
