46
13.6.1. Setting flow chart
The screen display examples shown below may differ from actual displays.
The on-screen indications shown in red here (actually shown by flashing cursors) are parameters or setting
contents to be selected with the Parameter setting knob, input channel selection key or other designated keys.
The indications of the [ ], [ ], [ ], and [ ] arrows represent that the screen is switched with the Screen
shift key.
Unless otherwise specified, use the Parameter setting knob for each parameter selection.
EVENT–SETT IN
G
EVENT01 N
O
N
E
Event number selection (p. 47-B1)
EVENT01 N
O
N
E
Event classification setting
(p. 47-B2)
EVENT01 R
O
U
T
E
(When Event classification is
set to ROUTE) (p. 47-B2)
Event classification setting
EVENT01 IN1
EVENT01
O
UT1
EVENT01TRI
G C
–IN01
EVENT01 SYNC
O
N
EVENT01 C
O
U
T
01
Input channel setting (p. 47-B3)
Output channel setting (p. 48-B4)
Trigger setting (p. 48-B5)
Interlock output control ON/OFF setting (p. 49-B8)
Interlock output terminal setting (p. 49-B9)
(When the interlock output control is ON)
Setting menu screen
EVENT01 B
G
M
E
ND
(When Event classification is
set to BGM END) (p. 47-B2)
Event classification setting
EVENT01TRI
G C
–IN01
Trigger setting (p. 49-B10)
EVENT01TRI
G C
–IN01
EVENT01 BASE
(When Event classification is
set to BASE)
(p. 47-B2)
EVENT01 BASE 02
BGM Event number selection
(p. 50-B11)
Trigger setting (p. 50-B12)
Event classification setting
TRI
GG
ER=LEVEL
Trigger type setting (p. 48-B6)
(When Trigger is set to the control input C-IN terminal)
(When Trigger type is set to PULSE)
Busy input terminal setting
(p. 49-B7)
BUSY– I N N
O
N
E
UTILITYMEMORY
Normal use state
PARAMETER
Press for over 2 seconds.
PARAMETER PARAMETER PARAMETER
To select,
INPUT SELECT
1 – 8
To select,
OUTPUT SEL
To determine,
ON/OFF
13.6. Event Setting (Only in the normal matrix operation)
