300Mbps Wireless N Gigabit ADSL2+ Modem Router User Guide
Figure 4-59
2. Enter the following data:
Destination IP Address: The address of the network or host that you want to assign to a
static route.
Subnet Mask: It determines which portion of an IP Address is the network portion, and
which portion is the host portion.
Gateway: Type in the correct gateway address for the static route.
Interface: Select the Interface from the drop-down list.
Status: Select Enabled or Disabled from the drop-down list.
3. Click Save to save your settings.
To modify or delete an existing entry:
1 Find the desired entry in the table.
2 Click Edit as desired on the Edit column.
Click the Enable/ Disabled Selected button to make selected entries enabled/ disabled.
Click the Delete Selected button to delete selected entries.
4.11.3 RIP Settings
Choose “Route Settings”“RIP Settings”, you can see the RIP (Routing Information Protocol)
screen which allows you to configure the RIP.
Figure 4-60
Note:
RIP cannot be configured on the WAN Interface which has NAT enabled (such as PPPoE).
61
